Main Page Sitemap

Cisco catalyst 2960 poe manual


cisco catalyst 2960 poe manual

10/100/1000 the tale of despereaux book Ports, the 10/100/1000 ports use RJ-45 connectors with Ethernet pinouts.
RPS LED Note The RPS LED is not present on the Catalyst 2960S-F48FPS-L, 2960S-F48LPS-L, 2960S-F24PS-L, 2960S-F48TS-L, 2960S-F24TS-L, 2960S-F48TS-S, and 2960S-F24TS-S switchesthese models do not support RPS.
Module slot numbers are 1 and.
170 West Tasman Drive, san Jose,.USB Type A port 6 10/100/1000 PoE ports 7, rJ-45 console port 8, ethernet management port, catalyst 2960-X and 2960-XR Switch Hardware Installation Guide.Figure 1-7 Switch LEDs and Mode Button System LED 6 Speed LED 1 2 2 RPS LED 7 Stack LED 2 3 3 Master LED 8 PoE LED 4 Status LED 9 Mode button 5 Duplex LED.For more jboss developer studio maven plugin information about the switch.THE software license AND limited warranty FOR THE accompanying product ARE SET forth IN THE information packet that shipped with THE product AND ARE.The first member.For information about configuring and monitoring PoE ports, see the switch software configuration guide.The maximum switch power output is either 740 W or 370 W, depending on the switch model.



The maximum cable length is 328 feet (100 meters).
Table 1-3 lists the switches that support the SFP modules.
Green RPS is connected and can provide).
For cable specifications, see Appendix B, Connec.For information about the stan.Unless otherwise noted, the term switch refers to a standalone switch and to a switch stack.ALL statements, information, AND recommendations IN this manual ARE believed TO BE accurate BUT ARE presented without warranty OF ANY kind, express OR implied.Some models of the switches support stacking through the Cisco FlexStack technology.This guide does not describe system messages that you might receive or how to configure your switch.


Sitemap